Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
3dprinting:lulzbot [2019-11-07 22:45] xro |
3dprinting:lulzbot [2019-11-08 19:48] xro |
||
---|---|---|---|
Line 210: | Line 210: | ||
|Max Temperature|240°C (exceed at risk of **DAMAGE**)| | |Max Temperature|240°C (exceed at risk of **DAMAGE**)| | ||
|Type|Budaschnozzle 2.0c| | |Type|Budaschnozzle 2.0c| | ||
+ | |||
+ | ===== Known Problems ===== | ||
+ | |||
+ | * Metal Platform holding print-bed is bent at all corners | ||
+ | * this makes leveling harder, as the bending angle is different in all four corners | ||
+ | * this means that the Z-offset (screw below Z-Endstop on controller-side) needs to be set lower that it originally was | ||
+ | * this means, when z-leveling, the extruder-header goes lower than it was designed for and sometimes makes hurtful noises | ||
+ | * Folien gehört getauscht | ||
+ | * muss aufgeheizt werden auf 60°C bevor neue Folien aufgeklebt wird, sonst bilden sich blasen | ||
===== Current Firmware Settings ===== | ===== Current Firmware Settings ===== |
realraum Graz, Brockmanngasse 15, 8010 Graz, realraum - Verein für Technik in Kultur und Gesellschaft